![]() ![]() Related stuff: Good detailed explanation of /etc/network/interfaces syntax? Example: auto enp3s0Ī detail that i have missed: The hwaddress configuration item needs to be after the gateway stanza, if you are setting a static ip address. Use the hwaddress ether inside your interface configuration block. I have been looking at tutorials online though I can't seem to get stuff right, and my computer even started acting very strangely a few times afterwards. I would like to change the mac address of all of my interfaces (enp3s0, wlp2s0) (lo is loopback so no need there), but I am unfamiliar with the commands in the /etc/network/interfaces file. I get the following output # interfaces(5) file used by ifup(8) and ifdown(8)Īnd when I do ifconfig on my ubuntu, I get back 3 different interfaces: ![]() Now when I use the following code: cat /etc/network/interfaces Stanza, e.g., right after the gateway line) so that the MAC address is On Debian, Ubuntu, and similar systems, place the following in theĪppropriate section of /etc/network/interfaces (within an iface So I found this great article online explaining how to change a Mac Address permanently through the /etc/network/interfaces file on my Ubuntu. ![]() How might I be able to specifically change the Mac Address of the enp3s0 and wlp2s0 interfaces through the /etc/network/interfaces file? What code would I have to include inside? I have been trying for some time now without success sadly enough.
0 Comments
Leave a Reply. |